News & Articles

PyroEDU
Get started learning to build your own electronics by following our FREE online courses below!
Learn More »

Categories

Sponsors

Build Like A Pyro!
Find many of the parts used on this site at our favorite online electronics shop
Take Me To The Gadgetory!
Manual Pick and Place Project

Posted September 14, 2015 by Chris

"I built a pick and place machine so I could build up my Motobrain project easier. I used MDF for the platforms. 12mm rail and linear bearings for the Y and Z axis bearings. THK linear motion guide for the X axis. The Z axis is a piece of carbon fiber tubing attached to a piece of laser cut acrylic. The nipples on the tube are 3D printed."

Leave a Reply