TTL Tilt Sensor

Jump To:
Hardware Design
           After all that crazy theory and schematics, it's finally time to build this thing! Below you can see a picture of all the parts used to build this tilt sensor. Click on the picture to enlarge it.

           Just like the previous two sections, the hardware construction will be split up into what I'm calling the analog side and the digital side. So let's get the analog side done!

Building The Analog Circuit
          The analog schematic is easier to wire up than the digital side, so it shouldn't take you too long. First gather all the parts to build the analog side of this circuit.

·Now, lay out the parts how you want them on the board.

·This is before the wire-wrapping is started. Follow the schematic and go!

·The analog side of this project has been connected together and works.

·That was the easy part, next comes the hard part.