The VGA Test Box: Parts List

Current Part:

Electrical Parts
LM7805 5v Voltage Regulator
PIC 18F452 Microcontroller
Female DB-15 VGA Connector
4 MHz Oscillator
SPST Buttons
SPDT Switch
15" Monitor
1µF Capacitor
30 pin SIP
SPTT Switch
Knob for the switch
540 point Breadboard
4x 10KΩ Resistors
Solder
Wire 22 AWG
Wire 30 AWG (aka Wirewrap; multiple colors is better)

Hardware Parts
Hobby Wood
8 small nails
5 minute E-poxy
Fancy Door Hinge
Plastic Sheet

Tools
Wirewrap Tool
Soldering Iron
Laptop Computer
MPLAB IDE (installed on Laptop)
PIC Programmer
Power Drill
Hammer
Jigsaw
Sand Paper


Parts List Details
           You may or may not be familiar with the parts above so a picture of each item has been included to clear up any possible questions. The only truely necessary parts for this project are the electrical parts, a wire wrap tool, computer & MPLAB IDE installed. Making the wooden enclosure is not necessary however it often looks nice to have the electronics hidden and just the electric input/output components (buttons, vga port, switches, etc..) exposed.



; ;