DC motor using L298

Pyro Project Ideas/Requests
Newbie Pyro
Posts: 1
Joined: Mon Jun 21, 2010 12:04 pm

DC motor using L298

Postby suspect » Tue Jun 29, 2010 4:06 pm

HI, currently i am doing basic motor control. i follow the schematic from L298 datasheet but my could not run. there is no voltage at the output. im using 12v motor , high torque. my diode is 1N4001 and the sense resistor is 10ohm

Pls help !! thanks!!

PyroElectro Admin
Posts: 1181
Joined: Mon Nov 12, 2007 9:24 pm
Location: Earth

Postby ThePyroElectro » Tue Jun 29, 2010 11:16 pm


Check the PWM signal input with an oscilloscope, or better, use a function generator for input and vary the duty cycle. Double, Triple-check all your wiring!

Return to “Request-a-Project”

Who is online

Users browsing this forum: No registered users and 1 guest