I have a PIC tach running on my yarn spinner and would like to up grade it and yours caught my attention.
I am not real familiar with C but I loaded it into MikrocPro using the New Proj Wizzard but can't get past the Includes. It can't open any of them.
Do I need to get these somewhere and load them in?
Also, before I spend a lot of time on this, is there any reason it can't run on a 16f628A? I don't have any 18 pin devices.
Thanks,
Jack
Marengo, Il
Digital Tach
Who is online
Users browsing this forum: No registered users and 5 guests