I really like your tutorials "Wireless XBee Motor Control" and "Wireless XBee Pan/Tilt With Servos".
I have an idea for a little improvement, so I was wondering if you would consider adding some code to the circuit...:
Is it possible that you add an option for third motor control, that would move the camera along some path? That could be used for driving the camera alongside a wall, or forward/reverse etc. Also, I was thinking about using 433MHz transmitter/receiver modules, since they are much cheaper than Xbee, but in that case some addressing should be added, so one transmitter could send to many receivers and control multiple cameras independently. Are you willing to add these options?
Questions and Comments on All Tutorials
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest