LED not blinking

Talk about the fourth PyroEDU course here.
calanita
Newbie Pyro
Posts: 2
Joined: Sat Jan 14, 2017 2:50 am

LED not blinking

Postby calanita » Sat Jan 14, 2017 2:55 am

The LED connected to d13 of the ATMEGA IC does not blink when power is applied to the board. I'm following the schematics in Lesson #2. How can I test to see whether my microcontroller is good or not? I double checked my schematic and everything appears to be hooked up correctly. Also (not surprisingly) the board will not respond when I try to upload my program to it (avrdude error). Thanks in advance for your help.

calanita
Newbie Pyro
Posts: 2
Joined: Sat Jan 14, 2017 2:50 am

Re: LED not blinking

Postby calanita » Mon Jan 16, 2017 8:23 pm

Never mind, I rebuilt my board and the LED is blinking now as it should upon powering up the microcontroller. I may have had some leads capacitor/resistor shorting together inadertently. :D


Return to “Introduction to Microcontrollers”

Who is online

Users browsing this forum: No registered users and 2 guests