Page 1 of 1

Test Post

Posted: Thu Oct 25, 2012 12:53 am
by ThePyroElectro
Just testing out the forums to make sure yah'll can post stuffs!

Re: Test Post

Posted: Fri Oct 26, 2012 5:39 pm
by PS1981
As the president said: Yes we can! :D

Re: Test Post

Posted: Fri Oct 26, 2012 8:41 pm
by ThePyroElectro
PS1981 wrote:As the president said: Yes we can! :D


:D sweet. Any new projects going on, on your end?

Re: Test Post

Posted: Sun Jan 06, 2013 8:33 am
by PS1981
Sorry, I wasn´t watching this post: How antisocial of me for not answering! :oops:

Yes Projects running: Building a PCB etching system. UV lighting works no probs - etching tank (automated) almost done. Next up drilling station. Possibly controlling this over I2C with Raspberry Pi. Will be a much bigger job though, and don´t know when I´ll get round to it.

Re: Test Post

Posted: Sun Jan 06, 2013 9:57 am
by ThePyroElectro
PS1981 wrote:Sorry, I wasn´t watching this post: How antisocial of me for not answering! :oops:

Yes Projects running: Building a PCB etching system. UV lighting works no probs - etching tank (automated) almost done. Next up drilling station. Possibly controlling this over I2C with Raspberry Pi. Will be a much bigger job though, and don´t know when I´ll get round to it.


Sounds like wayyy more sophisticated than the tupper ware + duct-tape + shake table I use for my ferric chloride etching :lol: . Wish I had more time to build just like everyone else... :wink: