Digital Tach

Questions and Comments on All Projects
K9ACT
Newbie Pyro
Posts: 1
Joined: Wed Jul 15, 2015 3:37 am

Digital Tach

Postby K9ACT » Wed Jul 15, 2015 3:50 am

I have a PIC tach running on my yarn spinner and would like to up grade it and yours caught my attention.

I am not real familiar with C but I loaded it into MikrocPro using the New Proj Wizzard but can't get past the Includes. It can't open any of them.

Do I need to get these somewhere and load them in?

Also, before I spend a lot of time on this, is there any reason it can't run on a 16f628A? I don't have any 18 pin devices.

Thanks,

Jack
Marengo, Il

Return to “Projects”

Who is online

Users browsing this forum: No registered users and 2 guests