Page 1 of 1

Backwards lettering

Posted: Wed Aug 21, 2013 9:56 am
by SuperTech-IT
I have a few cube controllers built to CHRs specifications.
When I run the PYRO code, the letters are backwards.
Upon diagnosis, it appears that your cube uses row 1 as row 8, 2 as 7, 3 as 6, and so on.
Are you aware that your cube, and therefore your code doesn't match the original author's design and code?
Just thought I'd let you know.

I checked this by the way with 3 different controller versions including my original hand wired prototype.