I have a few cube controllers built to CHRs specifications.
When I run the PYRO code, the letters are backwards.
Upon diagnosis, it appears that your cube uses row 1 as row 8, 2 as 7, 3 as 6, and so on.
Are you aware that your cube, and therefore your code doesn't match the original author's design and code?
Just thought I'd let you know.
I checked this by the way with 3 different controller versions including my original hand wired prototype.
Questions and Comments on All Projects
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests