I'm beginning to teach myself the basics in programming and though this project would be a good place to start. However i may have bitten off more than i can chew.
I've built the circuit. However i have used and Low Voltage Design. I am running the circuit off 3.3V and using an ADXL325 Accelerometer Eval Board with a PIC 18LF452. The ADXL325 Accel Eval Board
Is there any reason that your program is not compatible with the 18LF452? I was under the impression that the "LF" was just a lower voltage version of the "F". Is there anything i should change to get my project working (if possible) using the 18LF452? Any info would be great!!!
Questions and Comments on All Projects
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests