Personal G-Force Meter

Questions and Comments on All Projects
gibbo90
Newbie Pyro
Posts: 1
Joined: Mon Nov 19, 2012 9:05 pm

Personal G-Force Meter

Postby gibbo90 » Mon Nov 19, 2012 9:30 pm

Hi,

I'm beginning to teach myself the basics in programming and though this project would be a good place to start. However i may have bitten off more than i can chew.

I've built the circuit. However i have used and Low Voltage Design. I am running the circuit off 3.3V and using an ADXL325 Accelerometer Eval Board with a PIC 18LF452. The ADXL325 Accel Eval Board

Is there any reason that your program is not compatible with the 18LF452? I was under the impression that the "LF" was just a lower voltage version of the "F". Is there anything i should change to get my project working (if possible) using the 18LF452? Any info would be great!!!

Return to “Projects”

Who is online

Users browsing this forum: No registered users and 5 guests